Flashforge PETG 1kg 1.75mm - Fits the Creator Pro, Guider 2/2S & Creator 3
Flashforge PETG is great quality and a very reliable filament with extra toughness over PLA.
It prints at the same temps as Flashforge ABS with a temperature window of 220 - 240 degrees C.
The recommended bed temp is 80 degrees C.
You may need to decrease your extrusion ratio a little if you experience any burnt lumps building up on your nozzle and dropping off on your prints
PETG in general is sensitive to over extrusion.
The 1kg spools fit the Creator Pro rear spool holders as well as the spool holder for the Guider II
You can also use them on just about every other 3D printer with a 50mm or smaller spool mount.